Influence of layer-by-layer laser sintering conditions on the quality of sintered surface layer of products

Результат исследований: Материалы для книги/типы отчетовМатериалы для конференции

10 Цитирования (Scopus)

Аннотация

The influence of technological modes of sintering: the displacement velocity of laser beam V, laser power P, scanning step S and preheating temperature of powder material t on the quality of sintered surface layer of aluminum powder PA-4, copper powder PMS-1 and cobalt- chromium-molybdenum powder DSK-F75 were studied.

Язык оригиналаАнглийский
Название основной публикацииIOP Conference Series: Materials Science and Engineering
ИздательInstitute of Physics Publishing
Том91
Издание1
DOI
СостояниеОпубликовано - 14 сен 2015
Событие6th International Scientific Practical Conference on Innovative Technologies and Economics in Engineering - Yurga, Российская Федерация
Продолжительность: 21 мая 201523 мая 2015

Другое

Другое6th International Scientific Practical Conference on Innovative Technologies and Economics in Engineering
СтранаРоссийская Федерация
ГородYurga
Период21.5.1523.5.15

    Fingerprint

ASJC Scopus subject areas

  • Engineering(all)
  • Materials Science(all)

Цитировать

Saprykina, N. A., Saprykin, A. A., Borovikov, I. F., & Sharkeev, Y. P. (2015). Influence of layer-by-layer laser sintering conditions on the quality of sintered surface layer of products. В IOP Conference Series: Materials Science and Engineering (1 ред., Том 91). [012031] Institute of Physics Publishing. https://doi.org/10.1088/1757-899X/91/1/012031