Characterisation of the wall-slip during extrusion of heavy-clay products

I. Kocserha, A. L. Gömze, S. Kulkov, E. Kalatur, S. P. Buyakova, R. Géber, A. Y. Buzimov

Результат исследований: Материалы для журнала

1 Цитирования (Scopus)

Аннотация

During extrusion through the extrusion die, heavy-clay compounds are usually show plug flow with extensive slip at the wall of the die. In this study, the viscosity and the thickness of the slip layer were investigated. For the examination a brick-clay from Malyi (Hungary) deposit was applied as a raw material. The clay was characterised by XRPD, BET, SEM and granulometry. As the slip layer consists of suspension of the fine clay fraction so the clay minerals content of the clay (d<2μm) was separated by the help of sedimentation. The viscosity of suspension with different water content was measured by means of rotational viscosimeter. The thickness of the slip layer was calculated from the measured viscosity and other data obtained from an earlier study with capillary rheometer. The calculated thickness value showed a tendency to reach a limit value by increasing the extrusion speed.

Язык оригиналаАнглийский
Номер статьи012013
ЖурналJournal of Physics: Conference Series
Том790
Номер выпуска1
DOI
СостояниеОпубликовано - 16 фев 2017
Событие2nd International Conference on Rheology and Modeling of Materials, IC-RMM 2015 - Miskolc-Lillafured, Венгрия
Продолжительность: 5 окт 20159 окт 2015

ASJC Scopus subject areas

  • Physics and Astronomy(all)

Fingerprint Подробные сведения о темах исследования «Characterisation of the wall-slip during extrusion of heavy-clay products». Вместе они формируют уникальный семантический отпечаток (fingerprint).

  • Цитировать