Influence of transfer conditions on properties of graphene oxide Langmuir films

E. Seliverstova, N. Ibrayev, R. Dzhanabekova

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Abstract

The results of the study of the effect of value of surface pressure during film deposition on the structural and optical properties of Langmuir-Blodgett (LB) films of graphene oxide are presented. Measurement of compression isotherms of monolayers revealed that only gas phase observed when the small volume of the solution of graphene oxide is spreaded onto the surface of the subphase. For formation of monolayer in liquid state it's necessary to increase the amount of spreaded graphene oxide dispersion up to 2 ml. A further increase of spreaded dispersion leads to a reduction in the gas phase and specific molecular area. It is shown that the film obtained at a low surface pressure is more uniform in structure, but its optical density 30 % less than for the film prepared at high pressure. From the analysis of the area that occupied by the LB film on the surface of substrates, it was found that all monolayers that were transferred onto a solid substrate at high pressures occupy about 80% of the whole investigated area. This value is in good agreement with the data of transfer rate of the film.

Original languageEnglish
Title of host publicationProceedings of the 6th International Conference Nanomaterials
Subtitle of host publicationApplications and Properties, NAP 2016
PublisherInstitute of Electrical and Electronics Engineers Inc.
ISBN (Electronic)9781509025138
DOIs
Publication statusPublished - 28 Nov 2016
Externally publishedYes
Event6th International Conference Nanomaterials: Applications and Properties, NAP 2016 - Lviv, Ukraine
Duration: 14 Sep 201619 Sep 2016

Publication series

NameProceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016

Conference

Conference6th International Conference Nanomaterials: Applications and Properties, NAP 2016
CountryUkraine
CityLviv
Period14.9.1619.9.16

Fingerprint

Graphite
Langmuir Blodgett films
Graphene
Oxide films
Oxides
Monolayers
Gases
Density (optical)
Substrates
Isotherms
Structural properties
Compaction
Optical properties
Liquids

Keywords

  • Graphene oxid
  • LB film
  • Optical properties
  • Structure
  • Surface pressure

ASJC Scopus subject areas

  • Electronic, Optical and Magnetic Materials
  • Surfaces, Coatings and Films

Cite this

Seliverstova, E., Ibrayev, N., & Dzhanabekova, R. (2016). Influence of transfer conditions on properties of graphene oxide Langmuir films. In Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016 [7757275] (Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016). Institute of Electrical and Electronics Engineers Inc.. https://doi.org/10.1109/NAP.2016.7757275

Influence of transfer conditions on properties of graphene oxide Langmuir films. / Seliverstova, E.; Ibrayev, N.; Dzhanabekova, R.

Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016. Institute of Electrical and Electronics Engineers Inc., 2016. 7757275 (Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016).

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Seliverstova, E, Ibrayev, N & Dzhanabekova, R 2016, Influence of transfer conditions on properties of graphene oxide Langmuir films. in Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016., 7757275, Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016, Institute of Electrical and Electronics Engineers Inc., 6th International Conference Nanomaterials: Applications and Properties, NAP 2016, Lviv, Ukraine, 14.9.16. https://doi.org/10.1109/NAP.2016.7757275
Seliverstova E, Ibrayev N, Dzhanabekova R. Influence of transfer conditions on properties of graphene oxide Langmuir films. In Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016. Institute of Electrical and Electronics Engineers Inc. 2016. 7757275. (Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016). https://doi.org/10.1109/NAP.2016.7757275
Seliverstova, E. ; Ibrayev, N. ; Dzhanabekova, R. / Influence of transfer conditions on properties of graphene oxide Langmuir films. Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016. Institute of Electrical and Electronics Engineers Inc., 2016. (Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016).
@inproceedings{1dd09ee0cbcb4263b7bc4d5e795dd159,
title = "Influence of transfer conditions on properties of graphene oxide Langmuir films",
abstract = "The results of the study of the effect of value of surface pressure during film deposition on the structural and optical properties of Langmuir-Blodgett (LB) films of graphene oxide are presented. Measurement of compression isotherms of monolayers revealed that only gas phase observed when the small volume of the solution of graphene oxide is spreaded onto the surface of the subphase. For formation of monolayer in liquid state it's necessary to increase the amount of spreaded graphene oxide dispersion up to 2 ml. A further increase of spreaded dispersion leads to a reduction in the gas phase and specific molecular area. It is shown that the film obtained at a low surface pressure is more uniform in structure, but its optical density 30 {\%} less than for the film prepared at high pressure. From the analysis of the area that occupied by the LB film on the surface of substrates, it was found that all monolayers that were transferred onto a solid substrate at high pressures occupy about 80{\%} of the whole investigated area. This value is in good agreement with the data of transfer rate of the film.",
keywords = "Graphene oxid, LB film, Optical properties, Structure, Surface pressure",
author = "E. Seliverstova and N. Ibrayev and R. Dzhanabekova",
year = "2016",
month = "11",
day = "28",
doi = "10.1109/NAP.2016.7757275",
language = "English",
series = "Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016",
publisher = "Institute of Electrical and Electronics Engineers Inc.",
booktitle = "Proceedings of the 6th International Conference Nanomaterials",
address = "United States",

}

TY - GEN

T1 - Influence of transfer conditions on properties of graphene oxide Langmuir films

AU - Seliverstova, E.

AU - Ibrayev, N.

AU - Dzhanabekova, R.

PY - 2016/11/28

Y1 - 2016/11/28

N2 - The results of the study of the effect of value of surface pressure during film deposition on the structural and optical properties of Langmuir-Blodgett (LB) films of graphene oxide are presented. Measurement of compression isotherms of monolayers revealed that only gas phase observed when the small volume of the solution of graphene oxide is spreaded onto the surface of the subphase. For formation of monolayer in liquid state it's necessary to increase the amount of spreaded graphene oxide dispersion up to 2 ml. A further increase of spreaded dispersion leads to a reduction in the gas phase and specific molecular area. It is shown that the film obtained at a low surface pressure is more uniform in structure, but its optical density 30 % less than for the film prepared at high pressure. From the analysis of the area that occupied by the LB film on the surface of substrates, it was found that all monolayers that were transferred onto a solid substrate at high pressures occupy about 80% of the whole investigated area. This value is in good agreement with the data of transfer rate of the film.

AB - The results of the study of the effect of value of surface pressure during film deposition on the structural and optical properties of Langmuir-Blodgett (LB) films of graphene oxide are presented. Measurement of compression isotherms of monolayers revealed that only gas phase observed when the small volume of the solution of graphene oxide is spreaded onto the surface of the subphase. For formation of monolayer in liquid state it's necessary to increase the amount of spreaded graphene oxide dispersion up to 2 ml. A further increase of spreaded dispersion leads to a reduction in the gas phase and specific molecular area. It is shown that the film obtained at a low surface pressure is more uniform in structure, but its optical density 30 % less than for the film prepared at high pressure. From the analysis of the area that occupied by the LB film on the surface of substrates, it was found that all monolayers that were transferred onto a solid substrate at high pressures occupy about 80% of the whole investigated area. This value is in good agreement with the data of transfer rate of the film.

KW - Graphene oxid

KW - LB film

KW - Optical properties

KW - Structure

KW - Surface pressure

UR - http://www.scopus.com/inward/record.url?scp=85007174698&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85007174698&partnerID=8YFLogxK

U2 - 10.1109/NAP.2016.7757275

DO - 10.1109/NAP.2016.7757275

M3 - Conference contribution

AN - SCOPUS:85007174698

T3 - Proceedings of the 6th International Conference Nanomaterials: Applications and Properties, NAP 2016

BT - Proceedings of the 6th International Conference Nanomaterials

PB - Institute of Electrical and Electronics Engineers Inc.

ER -