Influence of rake angle tool on plastic deformation in chip formation when cutting

Research output: Chapter in Book/Report/Conference proceedingConference contribution

12 Citations (Scopus)

Abstract

The article considers experimental studies of plastic deformation in the area of chip formation when cutting copper M1. According to the results of the research the value of shear deformation was calculated. The change of a rake angle tool g leads to the change in the process of plastic deformation in the area of chip formation. It was found out that the maximum degree of shear deformation takes place in the contact area of tool tip and deformable sample.

Original languageEnglish
Title of host publicationApplied Mechanics and Materials
PublisherTrans Tech Publications Ltd
Pages525-529
Number of pages5
Volume682
ISBN (Print)9783038352815
DOIs
Publication statusPublished - 2014
Event5th International Scientific Practical Conference on Innovative Technologies and Economics in Engineering, 2014 - Yurga, Russian Federation
Duration: 22 May 201423 May 2014

Publication series

NameApplied Mechanics and Materials
Volume682
ISSN (Print)16609336
ISSN (Electronic)16627482

Other

Other5th International Scientific Practical Conference on Innovative Technologies and Economics in Engineering, 2014
CountryRussian Federation
CityYurga
Period22.5.1423.5.14

    Fingerprint

Keywords

  • Chip formation
  • Metal cutting
  • Plastic deformation
  • Tool

ASJC Scopus subject areas

  • Engineering(all)

Cite this

Filippov, A. V., & Gorbatenko, V. V. (2014). Influence of rake angle tool on plastic deformation in chip formation when cutting. In Applied Mechanics and Materials (Vol. 682, pp. 525-529). (Applied Mechanics and Materials; Vol. 682). Trans Tech Publications Ltd. https://doi.org/10.4028/www.scientific.net/AMM.682.525